Gateway 100 & 300 Installation Guide.

The installation of the Gateway 100 & 300 units are usually trouble free, in fact the most troublesome part of the installation is removing the head-unit. We have listed a few features regarding the installation that will help you when deciding whether or not you should try it yourself. (Please remember that The Gateway 100 & 300 products are car and radio specific and have different pin setting for different units)

Preparation,

Disconnect the head-unit (stereo) from the battery. If you have a security code applied ensure that you have it recorded.

Remove the Head-Unit

Often the radio will have a specific radio Key that will need to be used when removing the Stereo, (available at http://www.ipodcarkitdirect.co.uk/iPod_Car_Accessories/Radio_Keys/). Simply insert the keys into the slots and pull out the head-unit.

Remove the Original Harness

Remove the harness that is attached to the stereo, these harness look different in different car models and manufactures.
Replace the Dension Harness
Attach the Dension Harness to the stereo and then re attach the old harness to Dension harness. The Denson attachment should then be connected to the Dension PCB (black box).

Attach & route the application

When the harness have been connected together, connect the Dension application (Dock Cable or Active cradle) to the PCB and rout into the position that you would like it to be kept, (for dock cables this is usally in the glove box, active cradles are usually attached to the Dashboard)

Insert the head-unit

Insert the head-unit back into the original position and re connect to the battery.
Remember,
The Key code for the radio, updated iPod software & Dension software also resolve 99% of installation problems

For more detailed instruction refer to the Manual when purchased, or visit http://install.dension.com